SERENE Premium Emulsion INTERIOR

SIRCA Premium Emulsion is the best finish available in the market today. When applied on walls, it provides a smocth finish With an elegant appeal.



Available Packs

1 Ltr.4 Ltr.10 Ltr.20 Ltr.

Directions for use


The masonry surface to work on should be treated and well cured for the process of Sirca Cosmo Wall Primer. Better to allow a gap of 28 day before the process.

Filling for cracks

3mrm SIRCA Paints Crack Seal could be used for the fillers.


Surface should be free from any loose paint, dust of grease. Growths of fungus, algae or moss should be removed by wire brushing and water. In case of areas having excessive dampness use SIRCA Paints Damp Block to limit further dampness. Even after cleaning if the surface shows chalkiness, use SIRCA Paints Exterior Sealer to get an even surface.

Filling for holes & dents

In case of dents and holes use SIRCA Paints Acrylic Wall Putty or white cement and fine sand in the ratio 1:3.


  • Do not apply when ambient temperature is less than 10°C or if the temperature might drop to this level within 4 hrs of application.
  • Do not over-thin or over-extend the brush.
  • Tinted paints need thorough shaking immediately after tinter addition as well as before use.
  • For best performance-ensure that the surface is dry. On moisture meter it should be under the green zone. In case it is in Red zone, find out the source of water and address it before painting.
  • For better washability ensure the paint surface is cured for 2 weeks under normal atmospheric conditions. (30°C.; 50-60%RH)
  • Application of SIRCA Paints Acrylic Wall Putty and adherence to the painting system will lead to best results.

Painting Care

  • The Golden rule for removing any wall stains is that one should remove itimmediately.
  • Remove all dirt using a clean cloth or duster. Always remove dirt from top to bottom, this helps in avoiding loose dirt to smudge the walls.

Similar Products